Skip to content

Viking Dishwasher error code

Viking Dishwasher 4-4 Error Code

What 4-4 means on a Viking dishwasher, the checks that are safe to make and when it needs a technician.

Display readoutDallas

4-4Dishwasher display code

01

4-4

What it means

4-4 is described as “inlet valve error”.

4-4: inlet valve error.

02

Safe for owners

Check first

Switch the appliance off at the breaker for one minute, restore power and note whether the code returns. Nothing else should be opened or removed.

03

Likely cause

On most Viking appliances, 4-4 points to a control, sensor, ignition, heating, door-lock, water or drain issue that should be confirmed against the full model number before parts are replaced.

04

When to book

If the code comes back after the power reset, or there is water, a burning smell or a tripped breaker, stop using the appliance and book a visit with the full model number.

05

About 4-4

On a Viking dishwasher, the 4-4 indication has this documented meaning: “inlet valve error”.

Service referenceWhen the fill valve is energized, 120 VAC should be present between P6-3 and P10-1.
Applies toElectronic-control built-in dishwashers; displayed as flashes of POTS/PANS light (first digit) then NORMAL WASH light (second digit). Documented for: FDB451/VDB451 (SMK-0005, 2012); FDB301/RDDB201/RDDB301/VDB301 (SMK-0006, 2012); VDB325/VDB450 from 5/2010 and 325E/450E (SMK-0003, 2011); VDB200 (SMK-002, 2010)
MeaningInlet valve error: inlet valve current sense out of range.
Control generationLegacy
Code4-4
Service referenceVDB200: fill valve coil should read about 1.1k ohms.
06

Service procedures

The diagnostic notes describe these technical checks.

  • If voltage is present but no water enters, check the water supply and shut-off valve.
  • Check wires between the main control and the inlet valve.
07

Other messages and alarms

  • 4-3 — Dispenser error: dispenser current sense out of range.
  • 3-5 — Motor under-voltage error: motor control reports a low control voltage condition.
  • 4-1 — Temperature sensor error: temperature sensor reads out of range.
08

Before requesting a visit

Give details of the selected drying options as part of the symptom description. Mention the cycle in which the result changed. Leave the concealed appliance wiring alone when preparing for inspection.

09

Dallas booking details

For the initial discussion, have the unit identification and symptom notes and explain which owner checks were attempted. Diagnosis comes first; the findings lead to a written estimate, and the work requires your agreement before it starts. Request appliance service.

10

Sources

11

Questions about this code

What does 4-4 mean on a Viking dishwasher?

The manual describes the indication as “inlet valve error”. Match the model and control version before following the instructions.

What should I do before requesting dishwasher service?

Document normal dishwasher door closure when preparing for appliance inspection. Give details of if the equipment stops during the chosen cycle. Leave the unit service panels alone before the diagnostic visit.

13

Dishwasher models on file

All models

14

Work order

Book a Viking technician

Read the model and serial number off the rating plate and add them to the request — the technician checks parts for that exact unit before the visit.

Request a Viking repair

Ready to get your Viking appliance working again?

Diagnosis first, a written estimate before any work, parts matched to the full model number.

(415) 853-4850 Book a Repair