Skip to content

Viking Dishwasher error code

Viking Dishwasher 4-5 Error Code

What 4-5 means on a Viking dishwasher, the checks that are safe to make and when it needs a technician.

Display readoutDallas

4-5Dishwasher display code

01

4-5

What it means

4-5 is described as “fill too fast error”.

4-5: fill too fast error.

02

Safe for owners

Check first

Switch the appliance off at the breaker for one minute, restore power and note whether the code returns. Nothing else should be opened or removed.

03

Likely cause

On most Viking appliances, 4-5 points to a control, sensor, ignition, heating, door-lock, water or drain issue that should be confirmed against the full model number before parts are replaced.

04

When to book

If the code comes back after the power reset, or there is water, a burning smell or a tripped breaker, stop using the appliance and book a visit with the full model number.

05

About 4-5

The 4-5 indication on a Viking dishwasher is described in the manual as “fill too fast error”.

Code4-5
Applies toElectronic-control built-in dishwashers; displayed as flashes of POTS/PANS light (first digit) then NORMAL WASH light (second digit). Documented for: FDB451/VDB451 (SMK-0005, 2012)
Control generationLegacy
MeaningFill too fast error: pressure sensor reaches fill level too fast (abnormal pressure-sensor change).
06

Cause notes

The manufacturer guidance sets out these fault conditions.

  • Causes listed after checks: defective inlet valve, pressure sensor, or main control.
07

Technical fault guidance

The service guidance provides these diagnostic checks.

  • Make sure the unit is level front to back and side to side.
  • Verify house water pressure is within specifications.
08

Other signals to look up

  • 5-4 — Current sense error: main control reads current draw when no loads are active.
  • 4-1 — Temperature sensor error: temperature sensor reads out of range.
  • 5-1 — Vent error: vent current sense out of range.
09

Preparing for an appliance assessment

Tell the technician about any obstruction around the door alongside the chosen operating settings. Note whether the chosen wash cycle finishes. Leave the hidden electrical components alone when preparing for inspection.

10

When to request service in Dallas

For the service technician, collect the model details from the rating label and mention whether the reported problem returns. Assessment precedes decisions on proposed work; a written estimate follows, and you approve repairs before repair work begins. Book an assessment.

11

Sources

12

Questions about this code

What does 4-5 mean on a Viking dishwasher?

The manual describes the indication as “fill too fast error”. Match the model and control version before following the instructions.

What should I do before requesting dishwasher service?

Tell the repair technician about normal dishwasher door closure when preparing for appliance inspection. Describe if the unit stops during the selected cycle. Keep any enclosed electrical connections untouched during owner observations.

14

Dishwasher models on file

All models

15

Work order

Book a Viking technician

Read the model and serial number off the rating plate and add them to the request — the technician checks parts for that exact unit before the visit.

Request a Viking repair

Ready to get your Viking appliance working again?

Diagnosis first, a written estimate before any work, parts matched to the full model number.

(415) 853-4850 Book a Repair