Skip to content

Viking Dishwasher error code

Viking Dishwasher 5-2 Error Code

What 5-2 means on a Viking dishwasher, the checks that are safe to make and when it needs a technician.

Display readoutDallas

5-2Dishwasher display code

01

5-2

What it means

5-2 is described as “blower error”.

5-2: blower error.

02

Safe for owners

Check first

Switch the appliance off at the breaker for one minute, restore power and note whether the code returns. Nothing else should be opened or removed.

03

Likely cause

On most Viking appliances, 5-2 points to a control, sensor, ignition, heating, door-lock, water or drain issue that should be confirmed against the full model number before parts are replaced.

04

When to book

If the code comes back after the power reset, or there is water, a burning smell or a tripped breaker, stop using the appliance and book a visit with the full model number.

05

About 5-2

On a Viking dishwasher, the 5-2 indication has this documented meaning: “blower error”.

Applies toElectronic-control built-in dishwashers; displayed as flashes of POTS/PANS light (first digit) then NORMAL WASH light (second digit). Documented for: FDB451/VDB451 (SMK-0005, 2012); VDB325/VDB450 from 5/2010 and 325E/450E (SMK-0003, 2011)
Control generationLegacy
Code5-2
MeaningBlower error: blower current sense out of range.
06

Internal fault investigation

The service guidance provides these diagnostic checks.

  • During the dry cycle the blower pulls air from the dishwasher interior and exhausts it out the front kickplate grill.
  • Check wires between the main control and the blower.
07

More code guidance

  • 4-3 — Dispenser error: dispenser current sense out of range.
  • 5-4 — Current sense error: main control reads current draw when no loads are active.
  • BOTH LEDS FLASH — Both LED1 and LED2 flash continuously: moisture sensor detects water in the base pan (overflow or leak, or defective sensor).
08

Preparing for an appliance assessment

Describe whether the wash cycle finishes in the repair request. Describe whether water remains after the wash. Leave the concealed appliance wiring undisturbed until a technician has seen the appliance.

09

Repair appointments in Dallas

At booking, provide the complete serial and model identification and describe any changes in normal use. Assessment precedes decisions on proposed work; a written estimate describes the proposal, and approval is needed before repair work. Arrange diagnosis.

10

Sources

11

Questions about this code

What does 5-2 mean on a Viking dishwasher?

The manual describes the indication as “blower error”. Match the model and control version before following the instructions.

What should I do before requesting dishwasher service?

Report any obstruction around the door when preparing for appliance inspection. Tell the service professional about whether trouble appears during washing or draining. Leave the concealed appliance wiring undisturbed until a repair technician has seen the equipment.

13

Dishwasher models on file

All models

14

Work order

Book a Viking technician

Read the model and serial number off the rating plate and add them to the request — the technician checks parts for that exact unit before the visit.

Request a Viking repair

Ready to get your Viking appliance working again?

Diagnosis first, a written estimate before any work, parts matched to the full model number.

(415) 853-4850 Book a Repair