Viking Dishwasher error code
Viking Dishwasher F1 Error Code
What F1 means on a Viking dishwasher, the checks that are safe to make and when it needs a technician.
F1
What it means
F1 is described as “temperature stop fault”.
F1: temperature stop fault.
Safe for owners
Check first
Switch the appliance off at the breaker for one minute, restore power and note whether the code returns. Nothing else should be opened or removed.
Likely cause
On most Viking appliances, F1 points to a control, sensor, ignition, heating, door-lock, water or drain issue that should be confirmed against the full model number before parts are replaced.
When to book
If the code comes back after the power reset, or there is water, a burning smell or a tripped breaker, stop using the appliance and book a visit with the full model number.
About F1
On a Viking dishwasher, the F1 indication has this documented meaning: “temperature stop fault”.
| Meaning | Temperature stop fault: temperature rise under 50F in five minutes; program leaves heating stage and continues. Shown only in service menu. |
|---|---|
| Applies to | DFUD Designer Series dishwashers (DFUD042/142 service-menu section of the DFUD service manual); shown in service menu as LED pattern L1 with fault code on display |
| Code | F1 |
| Control generation | Legacy |
Internal fault investigation
The diagnostic notes give the following procedures.
- Check list given: element, thermistor, water level, circulation pump, control unit, wiring.
Other messages and alarms
- F3 — Thermistor fault: thermistor interrupted or above 176F; program leaves heating stage and continues. Shown only in service menu.
- BOTH LEDS FLASH — Both LED1 and LED2 flash continuously: moisture sensor detects water in the base pan (overflow or leak, or defective sensor).
- F2 — Overfilling: too much water (pressure sensor or float); if not evacuated within 60 seconds the program is interrupted and the drain pump runs.
Getting ready for diagnosis
Tell the technician about the exact wash-control message alongside the chosen operating settings. Note a message that returns during usual control use. Leave the concealed appliance wiring untouched during owner observations.
Booking a Dallas repair visit
For the service professional, collect the equipment identification details and explain which owner checks were attempted. Assessment precedes decisions about the repair; a written repair estimate follows, and the repair proceeds only after your authorization. Book an assessment.
Sources
Questions about this code
What does F1 mean on a Viking dishwasher?
The manual describes the indication as “temperature stop fault”. Match the model and control version before following the instructions.
What should I do before requesting dishwasher service?
Tell the technician about normal dishwasher door closure as part of the reported problem description. Provide an account of if the machine stops during the selected cycle. Keep the concealed appliance wiring undisturbed until a technician has seen the equipment.
Dishwasher models on file
- DFUD04224-inch built-in dishwasherDesigner Series Undercounter Dishwasher.
- FDWU52424-inch panel-ready built-in dishwasher24-inch Dishwasher with Optional Custom Panel.
- FDWU524WS24-inch panel-ready built-in dishwasher with water softener24-inch Dishwasher with Water Softener and Optional Custom Panel.
- FDWU72424-inch panel-ready built-in dishwasher24-inch Dishwasher with Optional Custom Panel.
Work order
Book a Viking technician
Read the model and serial number off the rating plate and add them to the request — the technician checks parts for that exact unit before the visit.
- Phone(415) 853-4850
- Emailservice
@vikingdallas .com - HoursMon–Sat 8:00 AM – 7:00 PM
- Service area11 counties across Dallas–Fort Worth
Request a Viking repair
Ready to get your Viking appliance working again?
Diagnosis first, a written estimate before any work, parts matched to the full model number.