Viking Dishwasher error code
Viking Dishwasher F5 Error Code
What F5 means on a Viking dishwasher, the checks that are safe to make and when it needs a technician.
F5
What it means
F5 is described as “valve leakage”.
F5: valve leakage.
Safe for owners
Check first
Switch the appliance off at the breaker for one minute, restore power and note whether the code returns. Nothing else should be opened or removed.
Likely cause
On most Viking appliances, F5 points to a control, sensor, ignition, heating, door-lock, water or drain issue that should be confirmed against the full model number before parts are replaced.
When to book
If the code comes back after the power reset, or there is water, a burning smell or a tripped breaker, stop using the appliance and book a visit with the full model number.
About F5
For a Viking dishwasher, code F5 carries the documented description “valve leakage”.
| Code | F5 |
|---|---|
| Meaning | Valve leakage: more than 80 pulses detected while inlet valve is deactivated; program in progress is interrupted and drain pump runs. |
| Applies to | DFUD Designer Series dishwashers (DFUD042/142 service-menu section of the DFUD service manual); shown in service menu as LED pattern L5 with fault code on display |
| Control generation | Legacy |
Service procedures
The service notes identify these diagnostic checks.
- The matching owner message (valve leakage) says shut off the water tap and contact service.
- Check list given: leakage through the inlet valve, flow sensor.
What can trigger the signal
The manual describes these fault conditions.
- Certain models try to remedy the leak first.
Preparing for an appliance assessment
Describe whether the wash cycle finishes in the repair request. Note whether the chosen wash cycle finishes. Keep all internal wiring connections untouched while checking external controls.
Discussing repairs in Dallas
For the service professional, collect the model identification from the rating label and mention whether the reported problem returns. The technician investigates the operating concern first; you receive a written repair estimate, and you approve repairs before work begins. Arrange diagnosis.
Sources
Questions about this code
What does F5 mean on a Viking dishwasher?
The manual describes the indication as “valve leakage”. Match the model and control version before following the instructions.
What should I do before requesting dishwasher service?
Provide details about any obstruction around the door in the repair request. Explain if the appliance stops during the chosen cycle. Leave the electrical service covers undisturbed until a technician has seen the appliance.
Dishwasher models on file
- DFUD04224-inch built-in dishwasherDesigner Series Undercounter Dishwasher.
- FDWU52424-inch panel-ready built-in dishwasher24-inch Dishwasher with Optional Custom Panel.
- FDWU524WS24-inch panel-ready built-in dishwasher with water softener24-inch Dishwasher with Water Softener and Optional Custom Panel.
- FDWU72424-inch panel-ready built-in dishwasher24-inch Dishwasher with Optional Custom Panel.
Work order
Book a Viking technician
Read the model and serial number off the rating plate and add them to the request — the technician checks parts for that exact unit before the visit.
- Phone(415) 853-4850
- Emailservice
@vikingdallas .com - HoursMon–Sat 8:00 AM – 7:00 PM
- Service area11 counties across Dallas–Fort Worth
Request a Viking repair
Ready to get your Viking appliance working again?
Diagnosis first, a written estimate before any work, parts matched to the full model number.