Viking Dishwasher error code
Viking Dishwasher F6 Error Code
What F6 means on a Viking dishwasher, the checks that are safe to make and when it needs a technician.
F6
What it means
F6 is described as “pressure sensor fault”.
F6: pressure sensor fault.
Safe for owners
Check first
Switch the appliance off at the breaker for one minute, restore power and note whether the code returns. Nothing else should be opened or removed.
Likely cause
On most Viking appliances, F6 points to a control, sensor, ignition, heating, door-lock, water or drain issue that should be confirmed against the full model number before parts are replaced.
When to book
If the code comes back after the power reset, or there is water, a burning smell or a tripped breaker, stop using the appliance and book a visit with the full model number.
About F6
On a Viking dishwasher, the F6 indication has this documented meaning: “pressure sensor fault”.
| Control generation | Legacy |
|---|---|
| Applies to | DFUD Designer Series dishwashers (DFUD042/142 service-menu section of the DFUD service manual); shown in service menu as LED pattern L6 with fault code on display |
| Meaning | Pressure sensor fault: output signal above 4.8 V; program continues. Shown only in service menu. |
| Code | F6 |
Technical fault guidance
The service guidance details these internal checks.
- Check list given: pressure sensor, control unit, wiring.
Other codes in the appliance documentation
- F7 — Pumping out fault: water not evacuated after 120 seconds of pumping out; program interrupted.
- Fb — Spray arm divider fault: position contact continuously closed or open; program proceeds. Shown only in service menu.
- F8 — Blocked filter: pressure sensor senses excessively low pressure during final rinse; indicated after end of program.
Owner observations and safe checks
Write down the exact wash-control message in the repair request. Note a message that returns during usual control use. Leave any enclosed electrical connections undisturbed while recording the concern.
Dallas service and preparation
For the service technician, collect the complete serial and model identification and describe the sequence of events. Inspection comes before proposed repairs; the repair proposal includes a written repair estimate, so you can decide before repairs proceed. Contact the service team.
Sources
Questions about this code
What does F6 mean on a Viking dishwasher?
The manual describes the indication as “pressure sensor fault”. Match the model and control version before following the instructions.
What should I do before requesting dishwasher service?
Provide details about usual dishwasher door closure alongside the chosen operating settings. Give details of whether water remains after the wash. Keep the internal electrical components undisturbed until an appliance technician has seen the appliance.
Dishwasher models on file
- DFUD04224-inch built-in dishwasherDesigner Series Undercounter Dishwasher.
- FDWU52424-inch panel-ready built-in dishwasher24-inch Dishwasher with Optional Custom Panel.
- FDWU524WS24-inch panel-ready built-in dishwasher with water softener24-inch Dishwasher with Water Softener and Optional Custom Panel.
- FDWU72424-inch panel-ready built-in dishwasher24-inch Dishwasher with Optional Custom Panel.
Work order
Book a Viking technician
Read the model and serial number off the rating plate and add them to the request — the technician checks parts for that exact unit before the visit.
- Phone(415) 853-4850
- Emailservice
@vikingdallas .com - HoursMon–Sat 8:00 AM – 7:00 PM
- Service area11 counties across Dallas–Fort Worth
Request a Viking repair
Ready to get your Viking appliance working again?
Diagnosis first, a written estimate before any work, parts matched to the full model number.