Viking Dishwasher error code
Viking Dishwasher F9 Error Code
What F9 means on a Viking dishwasher, the checks that are safe to make and when it needs a technician.
F9
What it means
F9 is described as “circulation fault”.
F9: circulation fault.
Safe for owners
Check first
Switch the appliance off at the breaker for one minute, restore power and note whether the code returns. Nothing else should be opened or removed.
Likely cause
On most Viking appliances, F9 points to a control, sensor, ignition, heating, door-lock, water or drain issue that should be confirmed against the full model number before parts are replaced.
When to book
If the code comes back after the power reset, or there is water, a burning smell or a tripped breaker, stop using the appliance and book a visit with the full model number.
About F9
Viking describes code F9 on this dishwasher with the wording “circulation fault”.
| Code | F9 |
|---|---|
| Meaning | Circulation fault: pressure sensor reads excessively low or high pressure; program leaves heating stage and continues. Shown only in service menu. |
| Control generation | Legacy |
| Applies to | DFUD Designer Series dishwashers (DFUD042/142 service-menu section of the DFUD service manual); shown in service menu as LED pattern L1+L4 with fault code on display |
Technical fault guidance
The service notes identify the following procedures.
- Check list given: circulation pump, filter, water level, pressure chamber, pressure sensor.
Other signals to look up
- Fb — Spray arm divider fault: position contact continuously closed or open; program proceeds. Shown only in service menu.
- F5 — Valve leakage: more than 80 pulses detected while inlet valve is deactivated; program in progress is interrupted and drain pump runs.
- F7 — Pumping out fault: water not evacuated after 120 seconds of pumping out; program interrupted.
Preparing for an appliance assessment
Document the selected drying options as part of the symptom description. Mention the cycle in which the result changed. Leave all internal wiring connections undisturbed until a technician has seen the appliance.
Discussing repairs in Dallas
For the initial discussion, have the appliance identification and symptom notes, plus the original display wording. The technician investigates the reported problem first; you receive a written estimate with no repairs started without approval. Request appliance service.
Sources
Questions about this code
What does F9 mean on a Viking dishwasher?
The manual describes the indication as “circulation fault”. Match the model and control version before following the instructions.
What should I do before requesting dishwasher service?
Explain any obstruction around the door as part of the symptom description. Describe whether water remains after the wash. Keep all concealed wiring connections untouched while checking external controls.
Dishwasher models on file
- DFUD04224-inch built-in dishwasherDesigner Series Undercounter Dishwasher.
- FDWU52424-inch panel-ready built-in dishwasher24-inch Dishwasher with Optional Custom Panel.
- FDWU524WS24-inch panel-ready built-in dishwasher with water softener24-inch Dishwasher with Water Softener and Optional Custom Panel.
- FDWU72424-inch panel-ready built-in dishwasher24-inch Dishwasher with Optional Custom Panel.
Work order
Book a Viking technician
Read the model and serial number off the rating plate and add them to the request — the technician checks parts for that exact unit before the visit.
- Phone(415) 853-4850
- Emailservice
@vikingdallas .com - HoursMon–Sat 8:00 AM – 7:00 PM
- Service area11 counties across Dallas–Fort Worth
Request a Viking repair
Ready to get your Viking appliance working again?
Diagnosis first, a written estimate before any work, parts matched to the full model number.