Viking Dishwasher error code
Viking Dishwasher Fb Error Code
What Fb means on a Viking dishwasher, the checks that are safe to make and when it needs a technician.
Fb
What it means
Fb is described as “spray arm divider fault”.
Fb: spray arm divider fault.
Safe for owners
Check first
Switch the appliance off at the breaker for one minute, restore power and note whether the code returns. Nothing else should be opened or removed.
Likely cause
On most Viking appliances, Fb points to a control, sensor, ignition, heating, door-lock, water or drain issue that should be confirmed against the full model number before parts are replaced.
When to book
If the code comes back after the power reset, or there is water, a burning smell or a tripped breaker, stop using the appliance and book a visit with the full model number.
About Fb
Viking describes code Fb on this dishwasher with the wording “spray arm divider fault”.
| Control generation | Legacy |
|---|---|
| Applies to | DFUD Designer Series dishwashers (DFUD042/142 service-menu section of the DFUD service manual); shown in service menu as LED pattern L1+L6 with fault code on display |
| Meaning | Spray arm divider fault: position contact continuously closed or open; program proceeds. Shown only in service menu. |
| Code | Fb |
Service procedures
The technical reference details the service notes below.
- Check list for this code: spray arm divider, gear box function, contacts and wiring.
- Spray arm divider (120 V, 60 Hz) is listed at 2.6K ohm in the component resistance list.
Other messages and alarms
- F8 — Blocked filter: pressure sensor senses excessively low pressure during final rinse; indicated after end of program.
- F7 — Pumping out fault: water not evacuated after 120 seconds of pumping out; program interrupted.
- F6 — Pressure sensor fault: output signal above 4.8 V; program continues. Shown only in service menu.
What to check without opening panels
Report any visible standing water when arranging a visit. Consult the owner manual before carrying out accessible cleaning an owner-accessible filter. Leave the concealed appliance wiring alone before the diagnostic visit.
Dallas service and preparation
For the initial discussion, have the unit identification and symptom notes and describe the sequence of events. Repair decisions follow diagnosis; a written repair estimate follows, and the repair proceeds only after your agreement. Send a service request.
Sources
Questions about this code
What does Fb mean on a Viking dishwasher?
The manual describes the indication as “spray arm divider fault”. Match the model and control version before following the instructions.
What should I do before requesting dishwasher service?
Write down whether the wash cycle finishes when preparing for appliance inspection. Identify when the wash or drain behavior changes. Keep the concealed electrical components undisturbed until a service technician has seen the appliance.
Dishwasher models on file
- DFUD04224-inch built-in dishwasherDesigner Series Undercounter Dishwasher.
- FDWU52424-inch panel-ready built-in dishwasher24-inch Dishwasher with Optional Custom Panel.
- FDWU524WS24-inch panel-ready built-in dishwasher with water softener24-inch Dishwasher with Water Softener and Optional Custom Panel.
- FDWU72424-inch panel-ready built-in dishwasher24-inch Dishwasher with Optional Custom Panel.
Work order
Book a Viking technician
Read the model and serial number off the rating plate and add them to the request — the technician checks parts for that exact unit before the visit.
- Phone(415) 853-4850
- Emailservice
@vikingdallas .com - HoursMon–Sat 8:00 AM – 7:00 PM
- Service area11 counties across Dallas–Fort Worth
Request a Viking repair
Ready to get your Viking appliance working again?
Diagnosis first, a written estimate before any work, parts matched to the full model number.