Viking Dishwasher error code
Viking Dishwasher F8 Error Code
What F8 means on a Viking dishwasher, the checks that are safe to make and when it needs a technician.
F8
What it means
F8 is described as “blocked filter”.
F8: blocked filter.
Safe for owners
Check first
Switch the appliance off at the breaker for one minute, restore power and note whether the code returns. Nothing else should be opened or removed.
Likely cause
On most Viking appliances, F8 points to a control, sensor, ignition, heating, door-lock, water or drain issue that should be confirmed against the full model number before parts are replaced.
When to book
If the code comes back after the power reset, or there is water, a burning smell or a tripped breaker, stop using the appliance and book a visit with the full model number.
About F8
The F8 indication on a Viking dishwasher is described in the manual as “blocked filter”.
| Applies to | DFUD Designer Series dishwashers (DFUD042/142 service-menu section of the DFUD service manual); shown in service menu as LED pattern L1+L3 with fault code on display |
|---|---|
| Control generation | Legacy |
| Meaning | Blocked filter: pressure sensor senses excessively low pressure during final rinse; indicated after end of program. |
| Code | F8 |
Work for a technician
The fault reference gives these diagnostic checks.
- Check list given: filter, sump (pressure chamber), pressure sensor.
Other messages and alarms
- F9 — Circulation fault: pressure sensor reads excessively low or high pressure; program leaves heating stage and continues. Shown only in service menu.
- F7 — Pumping out fault: water not evacuated after 120 seconds of pumping out; program interrupted.
- F5 — Valve leakage: more than 80 pulses detected while inlet valve is deactivated; program in progress is interrupted and drain pump runs.
Safe preparation for diagnosis
Document the selected drying options alongside the chosen operating settings. Mention the cycle in which the result changed. Leave any enclosed electrical connections alone when preparing for inspection.
Dallas booking details
For the initial discussion, have the identification label details and describe any changes during operation. The technician investigates the symptom first; a written estimate describes the proposal, and the repair proceeds only after your authorization. Book an assessment.
Sources
Questions about this code
What does F8 mean on a Viking dishwasher?
The manual describes the indication as “blocked filter”. Match the model and control version before following the instructions.
What should I do before requesting dishwasher service?
Tell the technician about any obstruction around the door before the diagnostic assessment. Describe if the equipment stops during the selected cycle. Leave any enclosed electrical connections undisturbed until a service professional has seen the appliance.
Dishwasher models on file
- DFUD04224-inch built-in dishwasherDesigner Series Undercounter Dishwasher.
- FDWU52424-inch panel-ready built-in dishwasher24-inch Dishwasher with Optional Custom Panel.
- FDWU524WS24-inch panel-ready built-in dishwasher with water softener24-inch Dishwasher with Water Softener and Optional Custom Panel.
- FDWU72424-inch panel-ready built-in dishwasher24-inch Dishwasher with Optional Custom Panel.
Work order
Book a Viking technician
Read the model and serial number off the rating plate and add them to the request — the technician checks parts for that exact unit before the visit.
- Phone(415) 853-4850
- Emailservice
@vikingdallas .com - HoursMon–Sat 8:00 AM – 7:00 PM
- Service area11 counties across Dallas–Fort Worth
Request a Viking repair
Ready to get your Viking appliance working again?
Diagnosis first, a written estimate before any work, parts matched to the full model number.