Skip to content

Viking Dishwasher error code

Viking Dishwasher 1-1 Error Code

What 1-1 means on a Viking dishwasher, the checks that are safe to make and when it needs a technician.

Display readoutDallas

1-1Dishwasher display code

01

1-1

What it means

1-1 is described as “moisture sensor disconnect”.

1-1: moisture sensor disconnect.

02

Safe for owners

Check first

Switch the appliance off at the breaker for one minute, restore power and note whether the code returns. Nothing else should be opened or removed.

03

Likely cause

On most Viking appliances, 1-1 points to a control, sensor, ignition, heating, door-lock, water or drain issue that should be confirmed against the full model number before parts are replaced.

04

When to book

If the code comes back after the power reset, or there is water, a burning smell or a tripped breaker, stop using the appliance and book a visit with the full model number.

05

About 1-1

Viking describes code 1-1 on this dishwasher with the wording “moisture sensor disconnect”.

MeaningMoisture sensor disconnect: moisture sensor reads out of normal range (wires disconnected, defective sensor or control board).
Control generationLegacy
Applies toElectronic-control built-in dishwashers; displayed as flashes of POTS/PANS light (first digit) then NORMAL WASH light (second digit). Documented for: FDB451/VDB451 (SMK-0005, 2012); FDB301/RDDB201/RDDB301/VDB301 (SMK-0006, 2012); VDB325/VDB450 from 5/2010 and 325E/450E (SMK-0003, 2011); VDB200 (SMK-002, 2010)
Code1-1
Service referenceMoisture sensor resistance between P8-1 and P8-2 should be 175K ohms.
06

Internal checks from the manual

The technical reference details these diagnostic checks.

  • Check that the wires to the moisture sensor in the base pan are connected.
  • The moisture sensor is mounted in the base pan of the dishwasher.
  • On the VDB200 the action is to verify the pan moisture sensor is connected and check its resistance.
08

Getting ready for diagnosis

Explain the selected drying options with the model identification. Mention the cycle in which the result changed. Keep the enclosed control circuits untouched during accessible care.

09

Booking a Dallas repair visit

For the service professional, collect the appliance identification details and describe any changes while the appliance runs. The visit begins with diagnosis; you receive a written repair estimate, and the repair proceeds only after your agreement. Book an assessment.

10

Sources

11

Questions about this code

What does 1-1 mean on a Viking dishwasher?

The manual describes the indication as “moisture sensor disconnect”. Match the model and control version before following the instructions.

What should I do before requesting dishwasher service?

Provide an account of normal dishwasher door closure alongside the chosen operating settings. Give details of if the equipment stops during the selected cycle. Leave all internal wiring connections untouched while checking external controls.

13

Dishwasher models on file

All models

14

Work order

Book a Viking technician

Read the model and serial number off the rating plate and add them to the request — the technician checks parts for that exact unit before the visit.

Request a Viking repair

Ready to get your Viking appliance working again?

Diagnosis first, a written estimate before any work, parts matched to the full model number.

(415) 853-4850 Book a Repair