Skip to content

Viking Dishwasher error code

Viking Dishwasher 2-2 Error Code

What 2-2 means on a Viking dishwasher, the checks that are safe to make and when it needs a technician.

Display readoutDallas

2-2Dishwasher display code

01

2-2

What it means

2-2 is described as “fill error”.

2-2: fill error.

02

Safe for owners

Check first

Switch the appliance off at the breaker for one minute, restore power and note whether the code returns. Nothing else should be opened or removed.

03

Likely cause

On most Viking appliances, 2-2 points to a control, sensor, ignition, heating, door-lock, water or drain issue that should be confirmed against the full model number before parts are replaced.

04

When to book

If the code comes back after the power reset, or there is water, a burning smell or a tripped breaker, stop using the appliance and book a visit with the full model number.

05

About 2-2

For a Viking dishwasher, code 2-2 carries the documented description “fill error”.

MeaningFill error: pressure sensor does not reach target fill pressure during a fill (non-pressure models: insufficient temperature change; VDB200: fill time-out).
Applies toElectronic-control built-in dishwashers; displayed as flashes of POTS/PANS light (first digit) then NORMAL WASH light (second digit). Documented for: FDB451/VDB451 (SMK-0005, 2012); FDB301/RDDB201/RDDB301/VDB301 (SMK-0006, 2012); VDB325/VDB450 from 5/2010 and 325E/450E (SMK-0003, 2011); VDB200 (SMK-002, 2010)
Control generationLegacy
Code2-2
06

Internal fault investigation

The service guidance provides the technical actions below.

  • VDB200: verify water pressure, inlet hose and water valve are not restricted.
  • Verify water is turned on to the dishwasher and the fill line is not kinked.
  • Check that there has not been a decrease in water pressure.
07

Cause notes

The applicable instructions include the causes below.

  • The 325/450 table adds a defective inlet valve as a possible cause.
08

Other signals to look up

  • 1-4 — Diverter timeout: main control activates the diverter but gets no feedback that the correct position was reached.
  • 2-4 — High level error: pressure sensor indicates water level above the high-level threshold.
  • 3-1 — User interface to main control communication error.
09

Safe preparation for diagnosis

Tell the technician about any visible standing water before the diagnostic assessment. Consult the owner manual before carrying out accessible cleaning an owner-accessible filter. Leave the enclosed control circuits untouched during owner observations.

10

When to request service in Dallas

Have ready the appliance model information from the appliance identification label and describe any changes in normal use. The visit begins with diagnosis; a written estimate describes the proposal, and work waits for your approval. Request appliance service.

11

Sources

12

Questions about this code

What does 2-2 mean on a Viking dishwasher?

The manual describes the indication as “fill error”. Match the model and control version before following the instructions.

What should I do before requesting dishwasher service?

Report any obstruction around the door when preparing for appliance inspection. Identify when the wash or drain behavior changes. Leave all hidden wiring connections untouched during owner observations.

14

Dishwasher models on file

All models

15

Work order

Book a Viking technician

Read the model and serial number off the rating plate and add them to the request — the technician checks parts for that exact unit before the visit.

Request a Viking repair

Ready to get your Viking appliance working again?

Diagnosis first, a written estimate before any work, parts matched to the full model number.

(415) 853-4850 Book a Repair