Skip to content

Viking Dishwasher error code

Viking Dishwasher 3-2 Error Code

What 3-2 means on a Viking dishwasher, the checks that are safe to make and when it needs a technician.

Display readoutDallas

3-2Dishwasher display code

01

3-2

What it means

3-2 is described as “pump flow error”.

3-2: pump flow error.

02

Safe for owners

Check first

Switch the appliance off at the breaker for one minute, restore power and note whether the code returns. Nothing else should be opened or removed.

03

Likely cause

On most Viking appliances, 3-2 points to a control, sensor, ignition, heating, door-lock, water or drain issue that should be confirmed against the full model number before parts are replaced.

04

When to book

If the code comes back after the power reset, or there is water, a burning smell or a tripped breaker, stop using the appliance and book a visit with the full model number.

05

About 3-2

The 3-2 indication on a Viking dishwasher is described in the manual as “pump flow error”.

MeaningPump flow error: insufficient or inconsistent water flow through the wash system; flow-through heater is not allowed to activate.
Control generationLegacy
Code3-2
Applies toElectronic-control built-in dishwashers; displayed as flashes of POTS/PANS light (first digit) then NORMAL WASH light (second digit). Documented for: FDB451/VDB451 (SMK-0005, 2012); FDB301/RDDB201/RDDB301/VDB301 (SMK-0006, 2012); VDB325/VDB450 from 5/2010 and 325E/450E (SMK-0003, 2011); VDB200 (SMK-002, 2010)
06

Internal fault investigation

The fault reference describes the technical actions below.

  • Service step: enable extended fill service mode by pressing and holding Normal Wash for 10 seconds.
  • Verify proper fill level.
  • Verify water is fully turned on, fill line not kinked, and filters not clogged.
07

Possible causes in the documentation

The manufacturer guidance sets out these fault conditions.

  • Remaining causes: defective wash motor, water inlet valve, or main control.
08

Further fault descriptions

  • 2-3 — Low level error: pressure sensor indicates water level below the low-level threshold.
  • 3-1 — User interface to main control communication error.
  • 4-1 — Temperature sensor error: temperature sensor reads out of range.
09

Safe preparation for diagnosis

Include information about any visible standing water as part of the symptom description. Consult the owner manual before carrying out accessible cleaning an owner-accessible filter. Leave the internal electrical connections untouched while checking external controls.

10

Booking a Dallas repair visit

At booking, provide the appliance identification and symptom notes and describe any changes while the appliance runs. The symptom is investigated before repairs; the proposed work is explained in writing with no repairs started without approval. Send a service request.

11

Sources

12

Questions about this code

What does 3-2 mean on a Viking dishwasher?

The manual describes the indication as “pump flow error”. Match the model and control version before following the instructions.

What should I do before requesting dishwasher service?

Provide details about usual dishwasher door closure when preparing for appliance inspection. Tell the repair technician about whether trouble appears during washing or draining. Leave the unit service panels intact for the service professional.

14

Dishwasher models on file

All models

15

Work order

Book a Viking technician

Read the model and serial number off the rating plate and add them to the request — the technician checks parts for that exact unit before the visit.

Request a Viking repair

Ready to get your Viking appliance working again?

Diagnosis first, a written estimate before any work, parts matched to the full model number.

(415) 853-4850 Book a Repair