Viking Dishwasher error code
Viking Dishwasher 3-4 Error Code
What 3-4 means on a Viking dishwasher, the checks that are safe to make and when it needs a technician.
3-4
What it means
3-4 is described as “motor status error”.
3-4: motor status error.
Safe for owners
Check first
Switch the appliance off at the breaker for one minute, restore power and note whether the code returns. Nothing else should be opened or removed.
Likely cause
On most Viking appliances, 3-4 points to a control, sensor, ignition, heating, door-lock, water or drain issue that should be confirmed against the full model number before parts are replaced.
When to book
If the code comes back after the power reset, or there is water, a burning smell or a tripped breaker, stop using the appliance and book a visit with the full model number.
About 3-4
Viking describes code 3-4 on this dishwasher with the wording “motor status error”.
| Code | 3-4 |
|---|---|
| Control generation | Legacy |
| Meaning | Motor status error: motor control reports an operation failure most likely caused by the motor. |
| Applies to | Electronic-control built-in dishwashers; displayed as flashes of POTS/PANS light (first digit) then NORMAL WASH light (second digit). Documented for: FDB451/VDB451 (SMK-0005, 2012); VDB325/VDB450 from 5/2010 and 325E/450E (SMK-0003, 2011) |
Cause notes
The manufacturer guidance describes these cause notes.
- Other causes listed: defective motor control, then defective machine control.
Service procedures
The technical reference identifies these diagnostic checks.
- Verify the connection between the motor control and the motor.
Before requesting a visit
Include information about the flashing dishwasher indicators without assuming a failed component. Note a message that returns during usual control use. Leave the concealed appliance wiring undisturbed while recording the concern.
Discussing repairs in Dallas
When arranging a visit, note the appliance identification and symptom notes and describe any changes in normal use. Assessment precedes decisions on proposed work; a written estimate describes the proposal, and you approve repairs before repair work begins. Arrange diagnosis.
Sources
- Viking Preferred Service Service Manual Built-In Dishwasher FDB451 VDB451, SMK-0005, Aug 2012 (Fail Codes, pp.12-13), hosted on uncleharrywizard.com
- Viking Preferred Service Service Manual Built-In Dishwasher VDB325 VDB450 (from 5/26/2010) VDB325E VDB450E, SMK-0003, Apr 2011 (Error Codes, pp.19-21), hosted on uncleharrywizard.com
Questions about this code
What does 3-4 mean on a Viking dishwasher?
The manual describes the indication as “motor status error”. Match the model and control version before following the instructions.
What should I do before requesting dishwasher service?
Tell the repair technician about normal dishwasher door closure alongside the chosen operating settings. Describe if the equipment stops during the selected cycle. Keep the unit service panels intact for the service professional.
Dishwasher models on file
- DFUD04224-inch built-in dishwasherDesigner Series Undercounter Dishwasher.
- FDWU52424-inch panel-ready built-in dishwasher24-inch Dishwasher with Optional Custom Panel.
- FDWU524WS24-inch panel-ready built-in dishwasher with water softener24-inch Dishwasher with Water Softener and Optional Custom Panel.
- FDWU72424-inch panel-ready built-in dishwasher24-inch Dishwasher with Optional Custom Panel.
Work order
Book a Viking technician
Read the model and serial number off the rating plate and add them to the request — the technician checks parts for that exact unit before the visit.
- Phone(415) 853-4850
- Emailservice
@vikingdallas .com - HoursMon–Sat 8:00 AM – 7:00 PM
- Service area11 counties across Dallas–Fort Worth
Request a Viking repair
Ready to get your Viking appliance working again?
Diagnosis first, a written estimate before any work, parts matched to the full model number.