Skip to content

Viking Dishwasher error code

Viking Dishwasher 3-5 Error Code

What 3-5 means on a Viking dishwasher, the checks that are safe to make and when it needs a technician.

Display readoutDallas

3-5Dishwasher display code

01

3-5

What it means

3-5 is described as “motor under-voltage error”.

3-5: motor under-voltage error.

02

Safe for owners

Check first

Switch the appliance off at the breaker for one minute, restore power and note whether the code returns. Nothing else should be opened or removed.

03

Likely cause

On most Viking appliances, 3-5 points to a control, sensor, ignition, heating, door-lock, water or drain issue that should be confirmed against the full model number before parts are replaced.

04

When to book

If the code comes back after the power reset, or there is water, a burning smell or a tripped breaker, stop using the appliance and book a visit with the full model number.

05

About 3-5

The 3-5 indication on a Viking dishwasher is described in the manual as “motor under-voltage error”.

Control generationLegacy
MeaningMotor under-voltage error: motor control reports a low control voltage condition.
Code3-5
Applies toElectronic-control built-in dishwashers; displayed as flashes of POTS/PANS light (first digit) then NORMAL WASH light (second digit). Documented for: FDB451/VDB451 (SMK-0005, 2012); VDB325/VDB450 from 5/2010 and 325E/450E (SMK-0003, 2011)
06

Conditions behind the message

The matching manual provides the listed fault conditions.

  • Last causes listed: defective machine control, defective motor control.
07

Work for a technician

The diagnostic notes identify these service checks.

  • Verify house voltage is in specification.
  • Verify the connection at the terminal block.
  • Verify the AC connection to the machine control and the connection between machine control and motor control.
08

Additional fault references

  • 4-2 — Wash heater error: wash heater current sense out of range.
  • 4-3 — Dispenser error: dispenser current sense out of range.
  • 4-1 — Temperature sensor error: temperature sensor reads out of range.
09

Getting ready for diagnosis

Include information about water remaining in the tub when arranging a visit. Consult the owner manual before carrying out accessible cleaning an owner-accessible filter. Keep any enclosed electrical connections untouched while checking external controls.

10

Repair appointments in Dallas

For the service professional, collect the complete model and serial identification and describe the sequence of events. The visit begins with diagnosis; the repair proposal includes a written repair estimate, and work waits for your authorization. Book an assessment.

11

Sources

12

Questions about this code

What does 3-5 mean on a Viking dishwasher?

The manual describes the indication as “motor under-voltage error”. Match the model and control version before following the instructions.

What should I do before requesting dishwasher service?

Give details of usual dishwasher door closure as part of the symptom description. Provide an account of if the machine stops during the chosen cycle. Keep the electrical service covers undisturbed until a service professional has seen the equipment.

14

Dishwasher models on file

All models

15

Work order

Book a Viking technician

Read the model and serial number off the rating plate and add them to the request — the technician checks parts for that exact unit before the visit.

Request a Viking repair

Ready to get your Viking appliance working again?

Diagnosis first, a written estimate before any work, parts matched to the full model number.

(415) 853-4850 Book a Repair