Skip to content

Viking Dishwasher error code

Viking Dishwasher 5-1 Error Code

What 5-1 means on a Viking dishwasher, the checks that are safe to make and when it needs a technician.

Display readoutDallas

5-1Dishwasher display code

01

5-1

What it means

5-1 is described as “vent error”.

5-1: vent error.

02

Safe for owners

Check first

Switch the appliance off at the breaker for one minute, restore power and note whether the code returns. Nothing else should be opened or removed.

03

Likely cause

On most Viking appliances, 5-1 points to a control, sensor, ignition, heating, door-lock, water or drain issue that should be confirmed against the full model number before parts are replaced.

04

When to book

If the code comes back after the power reset, or there is water, a burning smell or a tripped breaker, stop using the appliance and book a visit with the full model number.

05

About 5-1

For a Viking dishwasher, code 5-1 carries the documented description “vent error”.

Code5-1
MeaningVent error: vent current sense out of range.
Control generationLegacy
Applies toElectronic-control built-in dishwashers; displayed as flashes of POTS/PANS light (first digit) then NORMAL WASH light (second digit). Documented for: FDB451/VDB451 (SMK-0005, 2012); VDB325/VDB450 from 5/2010 and 325E/450E (SMK-0003, 2011)
06

Work for a technician

The diagnostic notes describe the listed service work.

  • The vent wax motor is energized together with the blower during the dry cycle.
  • Check wires between the main control and the vent.
07

Other codes in the appliance documentation

  • 5-4 — Current sense error: main control reads current draw when no loads are active.
  • 5-2 — Blower error: blower current sense out of range.
  • 5-5 — Internal error: main control or user interface detects a board-level failure.
08

Before requesting a visit

Record the exact wash-control message in the repair request. Note a message that returns during usual control use. Leave the concealed appliance wiring alone before the diagnostic visit.

09

When to request service in Dallas

Have ready the full model number and control message, plus the original display wording. The appliance is assessed first; the suggested work comes with a written estimate, and you approve repairs before repair work begins. Arrange diagnosis.

10

Sources

11

Questions about this code

What does 5-1 mean on a Viking dishwasher?

The manual describes the indication as “vent error”. Match the model and control version before following the instructions.

What should I do before requesting dishwasher service?

Report normal dishwasher door closure with the model identification. Report if the appliance stops during the selected cycle. Keep all enclosed wiring connections undisturbed until a repair technician has seen the appliance.

13

Dishwasher models on file

All models

14

Work order

Book a Viking technician

Read the model and serial number off the rating plate and add them to the request — the technician checks parts for that exact unit before the visit.

Request a Viking repair

Ready to get your Viking appliance working again?

Diagnosis first, a written estimate before any work, parts matched to the full model number.

(415) 853-4850 Book a Repair