Skip to content

Viking Dishwasher error code

Viking Dishwasher 5-3 Error Code

What 5-3 means on a Viking dishwasher, the checks that are safe to make and when it needs a technician.

Display readoutDallas

5-3Dishwasher display code

01

5-3

What it means

5-3 is described as “dry heater error”.

5-3: dry heater error.

02

Safe for owners

Check first

Switch the appliance off at the breaker for one minute, restore power and note whether the code returns. Nothing else should be opened or removed.

03

Likely cause

On most Viking appliances, 5-3 points to a control, sensor, ignition, heating, door-lock, water or drain issue that should be confirmed against the full model number before parts are replaced.

04

When to book

If the code comes back after the power reset, or there is water, a burning smell or a tripped breaker, stop using the appliance and book a visit with the full model number.

05

About 5-3

Viking describes code 5-3 on this dishwasher with the wording “dry heater error”.

Control generationLegacy
Code5-3
Applies toElectronic-control built-in dishwashers; displayed as flashes of POTS/PANS light (first digit) then NORMAL WASH light (second digit). Documented for: FDB451/VDB451 (SMK-0005, 2012); VDB325/VDB450 from 5/2010 and 325E/450E (SMK-0003, 2011)
MeaningDry heater error: dry heater current sense out of range (listed as N/A on the 451).
06

Where this guidance applies

The matching manual includes these control versions.

  • On the 325/450 line the dryer heater is a 450-only part.
  • The 451 manual states there is no heater element in its drying system.
07

Technical fault guidance

The diagnostic notes provide the listed service work.

  • Check wires between the main control and the dry heater.
  • The control board sends 120 volts to the dry heater when extra drying heat is needed.
08

More code guidance

  • 5-4 — Current sense error: main control reads current draw when no loads are active.
  • 5-2 — Blower error: blower current sense out of range.
  • BOTH LEDS FLASH — Both LED1 and LED2 flash continuously: moisture sensor detects water in the base pan (overflow or leak, or defective sensor).
09

Safe checks and useful observations

Report whether the wash cycle finishes when preparing for appliance inspection. Note whether the chosen wash cycle finishes. Keep the appliance service panels untouched during owner observations.

10

Booking a Dallas repair visit

For the service professional, collect the model identification from the rating label, with a description of the trouble. Assessment precedes decisions about the repair; the findings lead to a written estimate, with repair work subject to your authorization. Contact the service team.

11

Sources

12

Questions about this code

What does 5-3 mean on a Viking dishwasher?

The manual describes the indication as “dry heater error”. Match the model and control version before following the instructions.

What should I do before requesting dishwasher service?

Provide details about normal dishwasher door closure alongside the chosen operating settings. Describe if the equipment stops during the selected cycle. Leave the concealed appliance wiring untouched while checking external controls.

14

Dishwasher models on file

All models

15

Work order

Book a Viking technician

Read the model and serial number off the rating plate and add them to the request — the technician checks parts for that exact unit before the visit.

Request a Viking repair

Ready to get your Viking appliance working again?

Diagnosis first, a written estimate before any work, parts matched to the full model number.

(415) 853-4850 Book a Repair