Skip to content

Viking Dishwasher error code

Viking Dishwasher F2 Error Code

What F2 means on a Viking dishwasher, the checks that are safe to make and when it needs a technician.

Display readoutDallas

F2Dishwasher display code

01

F2

What it means

F2 is described as “overfilling”.

F2: overfilling.

02

Safe for owners

Check first

Switch the appliance off at the breaker for one minute, restore power and note whether the code returns. Nothing else should be opened or removed.

03

Likely cause

On most Viking appliances, F2 points to a control, sensor, ignition, heating, door-lock, water or drain issue that should be confirmed against the full model number before parts are replaced.

04

When to book

If the code comes back after the power reset, or there is water, a burning smell or a tripped breaker, stop using the appliance and book a visit with the full model number.

05

About F2

Viking describes code F2 on this dishwasher with the wording “overfilling”. Match the appliance to the documented control version.

MeaningOverfilling: too much water (pressure sensor or float); if not evacuated within 60 seconds the program is interrupted and the drain pump runs.
Applies toDFUD Designer Series dishwashers (DFUD042/142 service-menu section of the DFUD service manual); shown in service menu as LED pattern L2 with fault code on display
CodeF2
Control generationLegacy
06

Observable fault details

The applicable instructions set out the indications below.

  • The matching owner message (too much water in the dishwasher) says to phone service.
07

Technical fault guidance

The service notes list these diagnostic checks.

  • Check list given: drain pump, hose blockage, flow sensor, inlet valve, leakage, wiring.
08

Check a different display code

  • F5 — Valve leakage: more than 80 pulses detected while inlet valve is deactivated; program in progress is interrupted and drain pump runs.
  • F4 — Water intake fault: fewer than 80 pulses in 60 seconds, or correct pulse count not reached within 255 seconds; program interrupted.
  • 5-5 — Internal error: main control or user interface detects a board-level failure.
09

Safe checks and useful observations

Include information about any visible standing water without repeating unsafe operation. Consult the owner manual before carrying out accessible cleaning an owner-accessible filter. Leave the concealed appliance wiring intact for the service professional.

10

Preparing for a Dallas visit

When arranging a visit, note the appliance identification and symptom notes and describe the sequence of events. Inspection comes before proposed repairs; you receive a written repair estimate, and you approve repairs before work begins. Book an assessment.

11

Sources

12

Questions about this code

What does F2 mean on a Viking dishwasher?

The manual describes the indication as “overfilling”. Match the model and control version before following the instructions.

What should I do before requesting dishwasher service?

Tell the technician about regular dishwasher door closure alongside the chosen operating settings. Report if the appliance stops during the selected cycle. Leave the hidden electrical components intact for the service professional.

14

Dishwasher models on file

All models

15

Work order

Book a Viking technician

Read the model and serial number off the rating plate and add them to the request — the technician checks parts for that exact unit before the visit.

Request a Viking repair

Ready to get your Viking appliance working again?

Diagnosis first, a written estimate before any work, parts matched to the full model number.

(415) 853-4850 Book a Repair