Skip to content

Viking Dishwasher error code

Viking Dishwasher F3 Error Code

What F3 means on a Viking dishwasher, the checks that are safe to make and when it needs a technician.

Display readoutDallas

F3Dishwasher display code

01

F3

What it means

F3 is described as “thermistor fault”.

F3: thermistor fault.

02

Safe for owners

Check first

Switch the appliance off at the breaker for one minute, restore power and note whether the code returns. Nothing else should be opened or removed.

03

Likely cause

On most Viking appliances, F3 points to a control, sensor, ignition, heating, door-lock, water or drain issue that should be confirmed against the full model number before parts are replaced.

04

When to book

If the code comes back after the power reset, or there is water, a burning smell or a tripped breaker, stop using the appliance and book a visit with the full model number.

05

About F3

Viking describes code F3 on this dishwasher with the wording “thermistor fault”.

Control generationLegacy
MeaningThermistor fault: thermistor interrupted or above 176F; program leaves heating stage and continues. Shown only in service menu.
CodeF3
Applies toDFUD Designer Series dishwashers (DFUD042/142 service-menu section of the DFUD service manual); shown in service menu as LED pattern L3 with fault code on display
06

Internal fault investigation

The repair instructions list the service notes below.

  • Check list given: thermistor and control unit.
08

Before requesting a visit

Include information about the exact wash-control message when arranging a visit. Note a message that returns during usual control use. Leave the appliance service panels undisturbed until a technician has seen the appliance.

09

Dallas service and preparation

Have ready the exact model and observed symptoms and mention whether the reported problem returns. The symptom is investigated before repairs; the estimate is presented in writing with no repairs started without approval. Request appliance service.

10

Sources

11

Questions about this code

What does F3 mean on a Viking dishwasher?

The manual describes the indication as “thermistor fault”. Match the model and control version before following the instructions.

What should I do before requesting dishwasher service?

Report usual dishwasher door closure in the repair request. Tell the repair technician about whether trouble appears during washing or draining. Leave the enclosed electrical components undisturbed until a service professional has seen the unit.

13

Dishwasher models on file

All models

14

Work order

Book a Viking technician

Read the model and serial number off the rating plate and add them to the request — the technician checks parts for that exact unit before the visit.

Request a Viking repair

Ready to get your Viking appliance working again?

Diagnosis first, a written estimate before any work, parts matched to the full model number.

(415) 853-4850 Book a Repair