Skip to content

Viking Dishwasher error code

Viking Dishwasher 4-3 Error Code

What 4-3 means on a Viking dishwasher, the checks that are safe to make and when it needs a technician.

Display readoutDallas

4-3Dishwasher display code

01

4-3

What it means

4-3 is described as “dispenser error”.

4-3: dispenser error.

02

Safe for owners

Check first

Switch the appliance off at the breaker for one minute, restore power and note whether the code returns. Nothing else should be opened or removed.

03

Likely cause

On most Viking appliances, 4-3 points to a control, sensor, ignition, heating, door-lock, water or drain issue that should be confirmed against the full model number before parts are replaced.

04

When to book

If the code comes back after the power reset, or there is water, a burning smell or a tripped breaker, stop using the appliance and book a visit with the full model number.

05

About 4-3

On a Viking dishwasher, the 4-3 indication has this documented meaning: “dispenser error”.

Applies toElectronic-control built-in dishwashers; displayed as flashes of POTS/PANS light (first digit) then NORMAL WASH light (second digit). Documented for: FDB451/VDB451 (SMK-0005, 2012); FDB301/RDDB201/RDDB301/VDB301 (SMK-0006, 2012); VDB325/VDB450 from 5/2010 and 325E/450E (SMK-0003, 2011); VDB200 (SMK-002, 2010)
Service referenceVoltage between P4-1 and P4-4 should be 12 VDC when the dispenser is activated.
Code4-3
Service referenceVDB200: dispenser should read 8.3 ohms between P4-1 and P4-4.
Control generationLegacy
MeaningDispenser error: dispenser current sense out of range.
06

Internal checks from the manual

The service notes give these diagnostic checks.

  • Check wires between the main control and the dispenser.
07

Check a different display code

  • 4-4 — Inlet valve error: inlet valve current sense out of range.
  • 3-5 — Motor under-voltage error: motor control reports a low control voltage condition.
  • 3-4 — Motor status error: motor control reports an operation failure most likely caused by the motor.
08

Safe checks and useful observations

Give details of changes during dishwasher draining during the initial service discussion. Consult the owner manual before carrying out accessible cleaning an owner-accessible filter. Keep the electrical service covers untouched while checking external controls.

09

Dallas booking details

For the initial discussion, have the equipment identification details and describe any differences in normal use. Initial checks establish the repair proposal; a written repair estimate describes the proposal, and work waits for your agreement. Request appliance service.

10

Sources

11

Questions about this code

What does 4-3 mean on a Viking dishwasher?

The manual describes the indication as “dispenser error”. Match the model and control version before following the instructions.

What should I do before requesting dishwasher service?

Describe normal dishwasher door closure with the model identification. Keep a record of whether the wash stops or continues. Leave the internal electrical components untouched during owner observations.

13

Dishwasher models on file

All models

14

Work order

Book a Viking technician

Read the model and serial number off the rating plate and add them to the request — the technician checks parts for that exact unit before the visit.

Request a Viking repair

Ready to get your Viking appliance working again?

Diagnosis first, a written estimate before any work, parts matched to the full model number.

(415) 853-4850 Book a Repair