Viking Dishwasher error code
Viking Dishwasher 3-3 Error Code
What 3-3 means on a Viking dishwasher, the checks that are safe to make and when it needs a technician.
3-3
What it means
3-3 is described as “drain pump error”.
3-3: drain pump error.
Safe for owners
Check first
Switch the appliance off at the breaker for one minute, restore power and note whether the code returns. Nothing else should be opened or removed.
Likely cause
On most Viking appliances, 3-3 points to a control, sensor, ignition, heating, door-lock, water or drain issue that should be confirmed against the full model number before parts are replaced.
When to book
If the code comes back after the power reset, or there is water, a burning smell or a tripped breaker, stop using the appliance and book a visit with the full model number.
About 3-3
Viking describes code 3-3 on this dishwasher with the wording “drain pump error”.
| Control generation | Legacy |
|---|---|
| Service reference | VDB200 drain pump reads about 15.1 ohms between P6-4 and P10-1. |
| Service reference | In drain mode, voltage between P6-4 and neutral should be 120 VAC. |
| Applies to | Electronic-control built-in dishwashers; displayed as flashes of POTS/PANS light (first digit) then NORMAL WASH light (second digit). Documented for: FDB451/VDB451 (SMK-0005, 2012); FDB301/RDDB201/RDDB301/VDB301 (SMK-0006, 2012); VDB325/VDB450 from 5/2010 and 325E/450E (SMK-0003, 2011); VDB200 (SMK-002, 2010) |
| Meaning | Drain pump error: drain pump current sense out of range. |
| Code | 3-3 |
Internal fault investigation
The service guidance details the technical actions below.
- Check wires between the main control and the drain pump.
- If the pump reads 0 ohms replace it; if readings are correct, remove it and check for obstructions.
- VDB200: check drain pump resistance and check the pump for obstructions.
Additional fault references
Before requesting a visit
Report whether wash controls respond alongside the chosen operating settings. Note a message that returns during usual control use. Keep the electrical service covers undisturbed while recording the concern.
Discussing repairs in Dallas
Have ready the appliance model information from the appliance identification label and mention whether the reported problem returns. The technician investigates the reported problem first; the estimate is presented in writing, and you approve repairs before repair work begins. Contact the service team.
Sources
- Viking Preferred Service Service Manual Built-In Dishwasher FDB451 VDB451, SMK-0005, Aug 2012 (Fail Codes, pp.12-13), hosted on uncleharrywizard.com
- Viking Preferred Service Service Manual Built-In Dishwasher FDB301 RDDB201 RDDB301 VDB301, SMK-0006, Apr 2012 (Fail Codes, pp.12-13), hosted on uncleharrywizard.com
- Viking Preferred Service Service Manual Built-In Dishwasher VDB325 VDB450 (from 5/26/2010) VDB325E VDB450E, SMK-0003, Apr 2011 (Error Codes, pp.19-21), hosted on uncleharrywizard.com
- Viking Preferred Service Service Manual Built-In Dishwasher VDB200, SMK-002, May 2010 (Fail Codes, p.13), hosted on uncleharrywizard.com
Questions about this code
What does 3-3 mean on a Viking dishwasher?
The manual describes the indication as “drain pump error”. Match the model and control version before following the instructions.
What should I do before requesting dishwasher service?
Make a note of normal dishwasher door closure without assuming a failed component. Keep a record of whether the selected wash cycle finishes. Leave the equipment service panels alone before the diagnostic visit.
Dishwasher models on file
- DFUD04224-inch built-in dishwasherDesigner Series Undercounter Dishwasher.
- FDWU52424-inch panel-ready built-in dishwasher24-inch Dishwasher with Optional Custom Panel.
- FDWU524WS24-inch panel-ready built-in dishwasher with water softener24-inch Dishwasher with Water Softener and Optional Custom Panel.
- FDWU72424-inch panel-ready built-in dishwasher24-inch Dishwasher with Optional Custom Panel.
Work order
Book a Viking technician
Read the model and serial number off the rating plate and add them to the request — the technician checks parts for that exact unit before the visit.
- Phone(415) 853-4850
- Emailservice
@vikingdallas .com - HoursMon–Sat 8:00 AM – 7:00 PM
- Service area11 counties across Dallas–Fort Worth
Request a Viking repair
Ready to get your Viking appliance working again?
Diagnosis first, a written estimate before any work, parts matched to the full model number.