Skip to content

Viking Dishwasher error code

Viking Dishwasher 2-4 Error Code

What 2-4 means on a Viking dishwasher, the checks that are safe to make and when it needs a technician.

Display readoutDallas

2-4Dishwasher display code

01

2-4

What it means

2-4 is described as “high level error”.

2-4: high level error.

02

Safe for owners

Check first

Switch the appliance off at the breaker for one minute, restore power and note whether the code returns. Nothing else should be opened or removed.

03

Likely cause

On most Viking appliances, 2-4 points to a control, sensor, ignition, heating, door-lock, water or drain issue that should be confirmed against the full model number before parts are replaced.

04

When to book

If the code comes back after the power reset, or there is water, a burning smell or a tripped breaker, stop using the appliance and book a visit with the full model number.

05

About 2-4

For a Viking dishwasher, code 2-4 carries the documented description “high level error”.

Code2-4
Applies toElectronic-control built-in dishwashers; displayed as flashes of POTS/PANS light (first digit) then NORMAL WASH light (second digit). Documented for: FDB451/VDB451 (SMK-0005, 2012); VDB325/VDB450 from 5/2010 and 325E/450E (SMK-0003, 2011)
Service referenceA full sump should read approximately 3.5 VDC at the pressure sensor output.
MeaningHigh level error: pressure sensor indicates water level above the high-level threshold.
Control generationLegacy
06

Listed causes

The operating guidance provides these cause notes.

  • Excess water in the sump; check that items are secured in the rack.
07

Other signals to look up

  • 2-3 — Low level error: pressure sensor indicates water level below the low-level threshold.
  • 2-2 — Fill error: pressure sensor does not reach target fill pressure during a fill (non-pressure models: insufficient temperature change; VDB200: fill time-out).
  • 3-3 — Drain pump error: drain pump current sense out of range.
08

Safe checks and useful observations

Make a note of the exact wash-control message as part of the symptom description. Note a message that returns during usual control use. Keep the appliance service panels untouched during owner observations.

09

Dallas booking details

When arranging a visit, note the appliance model information as printed on the identification label and describe any changes while the appliance runs. Assessment precedes decisions about the repair; the repair proposal includes a written repair estimate, and work waits for your approval. Arrange diagnosis.

10

Sources

11

Questions about this code

What does 2-4 mean on a Viking dishwasher?

The manual describes the indication as “high level error”. Match the model and control version before following the instructions.

What should I do before requesting dishwasher service?

Tell the appliance technician about any obstruction around the door before the diagnostic assessment. Provide an account of if the appliance stops during the selected cycle. Leave any enclosed electrical connections undisturbed until a repair technician has seen the appliance.

13

Dishwasher models on file

All models

14

Work order

Book a Viking technician

Read the model and serial number off the rating plate and add them to the request — the technician checks parts for that exact unit before the visit.

Request a Viking repair

Ready to get your Viking appliance working again?

Diagnosis first, a written estimate before any work, parts matched to the full model number.

(415) 853-4850 Book a Repair