Viking Dishwasher error code
Viking Dishwasher 1-3 Error Code
What 1-3 means on a Viking dishwasher, the checks that are safe to make and when it needs a technician.
1-3
What it means
1-3 is described as “motor control communication error”.
1-3: motor control communication error.
Safe for owners
Check first
Switch the appliance off at the breaker for one minute, restore power and note whether the code returns. Nothing else should be opened or removed.
Likely cause
On most Viking appliances, 1-3 points to a control, sensor, ignition, heating, door-lock, water or drain issue that should be confirmed against the full model number before parts are replaced.
When to book
If the code comes back after the power reset, or there is water, a burning smell or a tripped breaker, stop using the appliance and book a visit with the full model number.
About 1-3
For a Viking dishwasher, code 1-3 carries the documented description “motor control communication error”.
| Code | 1-3 |
|---|---|
| Control generation | Legacy |
| Meaning | Motor control communication error: main control cannot communicate with the motor control. |
| Applies to | Electronic-control built-in dishwashers; displayed as flashes of POTS/PANS light (first digit) then NORMAL WASH light (second digit). Documented for: FDB451/VDB451 (SMK-0005, 2012); VDB325/VDB450 from 5/2010 and 325E/450E (SMK-0003, 2011) |
What can trigger the signal
The operating guidance identifies these possible causes.
- Possible causes listed after wiring: defective motor control, then defective control board.
Internal fault investigation
The repair instructions provide the service notes below.
- Check wires between the motor controller and the control board.
Other messages and alarms
- 1-1 — Moisture sensor disconnect: moisture sensor reads out of normal range (wires disconnected, defective sensor or control board).
- 2-1 — Pressure sensor disconnect: pressure sensor reads out of normal range (low).
- 1-4 — Diverter timeout: main control activates the diverter but gets no feedback that the correct position was reached.
Owner observations and safe checks
Document dishes remaining wet or soiled when arranging a visit. Mention the cycle in which the result changed. Keep the electrical service covers intact for the service professional.
Repair appointments in Dallas
For the initial discussion, have the complete serial and model identification, along with checks already attempted. The technician investigates the operating concern first; the estimate is presented in writing, and repairs require your approval. Contact the service team.
Sources
- Viking Preferred Service Service Manual Built-In Dishwasher FDB451 VDB451, SMK-0005, Aug 2012 (Fail Codes, pp.12-13), hosted on uncleharrywizard.com
- Viking Preferred Service Service Manual Built-In Dishwasher VDB325 VDB450 (from 5/26/2010) VDB325E VDB450E, SMK-0003, Apr 2011 (Error Codes, pp.19-21), hosted on uncleharrywizard.com
Questions about this code
What does 1-3 mean on a Viking dishwasher?
The manual describes the indication as “motor control communication error”. Match the model and control version before following the instructions.
What should I do before requesting dishwasher service?
Tell the service professional about regular dishwasher door closure with the model identification. Explain if the equipment stops during the selected cycle. Leave the electrical service covers undisturbed until a technician has seen the appliance.
Dishwasher models on file
- DFUD04224-inch built-in dishwasherDesigner Series Undercounter Dishwasher.
- FDWU52424-inch panel-ready built-in dishwasher24-inch Dishwasher with Optional Custom Panel.
- FDWU524WS24-inch panel-ready built-in dishwasher with water softener24-inch Dishwasher with Water Softener and Optional Custom Panel.
- FDWU72424-inch panel-ready built-in dishwasher24-inch Dishwasher with Optional Custom Panel.
Work order
Book a Viking technician
Read the model and serial number off the rating plate and add them to the request — the technician checks parts for that exact unit before the visit.
- Phone(415) 853-4850
- Emailservice
@vikingdallas .com - HoursMon–Sat 8:00 AM – 7:00 PM
- Service area11 counties across Dallas–Fort Worth
Request a Viking repair
Ready to get your Viking appliance working again?
Diagnosis first, a written estimate before any work, parts matched to the full model number.