Viking Range error code
Viking Range NO PROBE Error Code
What NO PROBE means on a Viking range, the checks that are safe to make and when it needs a technician.
NO PROBE
What it means
NO PROBE is described as “open or removed meat probe”.
NO PROBE: open or removed meat probe.
Safe for owners
Check first
Switch the appliance off at the breaker for one minute, restore power and note whether the code returns. Nothing else should be opened or removed.
Likely cause
On most Viking appliances, NO PROBE points to a control, sensor, ignition, heating, door-lock, water or drain issue that should be confirmed against the full model number before parts are replaced.
When to book
If the code comes back after the power reset, or there is water, a burning smell or a tripped breaker, stop using the appliance and book a visit with the full model number.
About NO PROBE
The NO PROBE indication on a Viking range is described in the manual as “open or removed meat probe”.
| Code | NO PROBE |
|---|---|
| Meaning | Meat probe open or removed during a cook-by-probe function (NO PROBE, COOK and UPPER/LOWER OVEN icons flash). Cancels probe cooking. |
| Applies to | Ranges and wall ovens with EOC4 control; wall ovens with TOD2/TOD3 clock show the F code, ranges show it as Cycle/Clean light flashes |
Service procedures
The service guidance gives these internal checks.
- Insert the meat probe and re-enter the timed or delay function.
Other codes in the appliance documentation
- F10 — Improper self-clean selection: a delayed self-clean cycle was attempted. Range: Clean on, Cycle flashes 10.
- F08 — Communication error: RS485 serial link lost between EOC4 and user interface. Range: Clean on, Cycle flashes 8.
- F09 — Runaway oven temperature: temperature above 650F for over 10 minutes with door unlocked. Range: Clean on, Cycle flashes 9.
Safe checks and useful observations
Document the exact cooking-control message before deciding on repair work. Include any change in the usual heating sequence. Keep any enclosed electrical connections undisturbed until a technician has seen the appliance.
Preparing for a Dallas visit
At booking, provide the model details from the rating label and describe any changes in normal use. The technician investigates the operating concern first; the repair proposal includes a written estimate, so no repair begins before you authorize it. Arrange diagnosis.
Sources
Questions about this code
What does NO PROBE mean on a Viking range?
The manual describes the indication as “open or removed meat probe”. Match the model and control version before following the instructions.
What should I do before requesting range service?
Document the chosen heating mode when discussing the appliance concern. Tell the appliance technician about the setting in use when trouble began. Leave the concealed electrical components alone before the diagnostic visit.
Range models on file
- RVER330130-inch freestanding radiant electric range with convection oven30-inch Self-Cleaning Electric Range.
- RVIR33030-inch freestanding induction range with self-cleaning electric oven30-inch Induction Range.
- TVDR36136-inch dual-fuel range with four gas burners and electric oven36-inch Tuscany Dual Fuel Range.
- TVDR48148-inch dual-fuel double-oven range48-inch Tuscany Dual Fuel Range.
Work order
Book a Viking technician
Read the model and serial number off the rating plate and add them to the request — the technician checks parts for that exact unit before the visit.
- Phone(415) 853-4850
- Emailservice
@vikingdallas .com - HoursMon–Sat 8:00 AM – 7:00 PM
- Service area11 counties across Dallas–Fort Worth
Request a Viking repair
Ready to get your Viking appliance working again?
Diagnosis first, a written estimate before any work, parts matched to the full model number.