Viking Range error code
Viking Range F04 Error Code
What F04 means on a Viking range, the checks that are safe to make and when it needs a technician.
F04
What it means
F04 is described as “shorted meat probe input”.
F04: shorted meat probe input.
Safe for owners
Check first
Switch the appliance off at the breaker for one minute, restore power and note whether the code returns. Nothing else should be opened or removed.
Likely cause
On most Viking appliances, F04 points to a control, sensor, ignition, heating, door-lock, water or drain issue that should be confirmed against the full model number before parts are replaced.
When to book
If the code comes back after the power reset, or there is water, a burning smell or a tripped breaker, stop using the appliance and book a visit with the full model number.
About F04
For a Viking range, code F04 carries the documented description “shorted meat probe input”.
| Meaning | Meat probe input shorted. Cancels cook-by-probe operation (priority B, non-critical). |
|---|---|
| Applies to | Ranges and wall ovens with EOC4 control; wall ovens with TOD2/TOD3 clock show the F code, ranges show it as Cycle/Clean light flashes |
| Code | F04 |
Service procedures
The fault reference gives these internal checks.
- Correct the short, then re-enter the timed or delay function.
Check a different display code
- F08 — Communication error: RS485 serial link lost between EOC4 and user interface. Range: Clean on, Cycle flashes 8.
- F07 — Door switch: door open during CLEAN (latch or door sensor failed, or door opened right after selecting CLEAN). Range: Clean on, Cycle flashes 7.
- F01 — Door latch: door lock not in unlocked position during cook or locked position during clean. Critical (priority A). Range: Clean light flashes once, Cycle light off.
Owner observations and safe checks
Document the exact cooking-control message without repeating unsafe operation. Include any change in the usual heating sequence. Leave any enclosed electrical connections untouched during owner observations.
When to request service in Dallas
When requesting service, provide the full model number and display indication, along with checks already attempted. The visit begins with diagnosis; a written repair estimate describes the proposal, and the repair proceeds only after your approval. Book an assessment.
Sources
Questions about this code
What does F04 mean on a Viking range?
The manual describes the indication as “shorted meat probe input”. Match the model and control version before following the instructions.
What should I do before requesting range service?
Tell the repair technician about which oven or zone changes without assuming a failed component. Write down the cooking mode that was selected. Leave all enclosed wiring connections untouched during owner-accessible care.
Range models on file
- RVER330130-inch freestanding radiant electric range with convection oven30-inch Self-Cleaning Electric Range.
- RVIR33030-inch freestanding induction range with self-cleaning electric oven30-inch Induction Range.
- TVDR36136-inch dual-fuel range with four gas burners and electric oven36-inch Tuscany Dual Fuel Range.
- TVDR48148-inch dual-fuel double-oven range48-inch Tuscany Dual Fuel Range.
Work order
Book a Viking technician
Read the model and serial number off the rating plate and add them to the request — the technician checks parts for that exact unit before the visit.
- Phone(415) 853-4850
- Emailservice
@vikingdallas .com - HoursMon–Sat 8:00 AM – 7:00 PM
- Service area11 counties across Dallas–Fort Worth
Request a Viking repair
Ready to get your Viking appliance working again?
Diagnosis first, a written estimate before any work, parts matched to the full model number.