Viking Range error code
Viking Range F10 Error Code
What F10 means on a Viking range, the checks that are safe to make and when it needs a technician.
F10
What it means
F10 is described as “improper self-clean selection”.
F10: improper self-clean selection.
Safe for owners
Check first
Switch the appliance off at the breaker for one minute, restore power and note whether the code returns. Nothing else should be opened or removed.
Likely cause
On most Viking appliances, F10 points to a control, sensor, ignition, heating, door-lock, water or drain issue that should be confirmed against the full model number before parts are replaced.
When to book
If the code comes back after the power reset, or there is water, a burning smell or a tripped breaker, stop using the appliance and book a visit with the full model number.
About F10
For a Viking range, code F10 carries the documented description “improper self-clean selection”.
| Meaning | Improper self-clean selection: a delayed self-clean cycle was attempted. Range: Clean on, Cycle flashes 10. |
|---|---|
| Code | F10 |
| Applies to | Ranges and wall ovens with EOC4 control; wall ovens with TOD2/TOD3 clock show the F code, ranges show it as Cycle/Clean light flashes |
Internal checks from the manual
The diagnostic notes describe the listed service work.
- Control shuts down into error mode; the source says to reset for a normal Self Clean cycle.
Check a different display code
- F06 — Invalid model header: model header undefined, read at power-up; control inoperable. Range: Clean on, Cycle flashes 2.
- F09 — Runaway oven temperature: temperature above 650F for over 10 minutes with door unlocked. Range: Clean on, Cycle flashes 9.
- NO PROBE — Meat probe open or removed during a cook-by-probe function (NO PROBE, COOK and UPPER/LOWER OVEN icons flash). Cancels probe cooking.
Before requesting a visit
Write down the accessible cooking-surface condition before deciding on repair work. Leave fixed wiring and supply fittings undisturbed. Keep the enclosed control circuits undisturbed until a technician has seen the appliance.
Discussing repairs in Dallas
When arranging a visit, note the model identification from the rating label, with a description of the trouble. Diagnosis comes first; you receive a written estimate, and the repair proceeds only after your authorization. Arrange diagnosis.
Sources
Questions about this code
What does F10 mean on a Viking range?
The manual describes the indication as “improper self-clean selection”. Match the model and control version before following the instructions.
What should I do before requesting range service?
Tell the technician about which oven or zone changes before deciding on repair work. Report whether the concern appears during heating or standby. Keep the enclosed control circuits untouched during owner observations.
Range models on file
- RVER330130-inch freestanding radiant electric range with convection oven30-inch Self-Cleaning Electric Range.
- RVIR33030-inch freestanding induction range with self-cleaning electric oven30-inch Induction Range.
- TVDR36136-inch dual-fuel range with four gas burners and electric oven36-inch Tuscany Dual Fuel Range.
- TVDR48148-inch dual-fuel double-oven range48-inch Tuscany Dual Fuel Range.
Work order
Book a Viking technician
Read the model and serial number off the rating plate and add them to the request — the technician checks parts for that exact unit before the visit.
- Phone(415) 853-4850
- Emailservice
@vikingdallas .com - HoursMon–Sat 8:00 AM – 7:00 PM
- Service area11 counties across Dallas–Fort Worth
Request a Viking repair
Ready to get your Viking appliance working again?
Diagnosis first, a written estimate before any work, parts matched to the full model number.