Skip to content

Viking Range error code

Viking Range F03 Error Code

What F03 means on a Viking range, the checks that are safe to make and when it needs a technician.

Display readoutDallas

F03Range display code

01

F03

What it means

F03 is described as “cooling fan feedback fault”.

F03: cooling fan feedback fault.

02

Safe for owners

Check first

Switch the appliance off at the breaker for one minute, restore power and note whether the code returns. Nothing else should be opened or removed.

03

Likely cause

On most Viking appliances, F03 points to a control, sensor, ignition, heating, door-lock, water or drain issue that should be confirmed against the full model number before parts are replaced.

04

When to book

If the code comes back after the power reset, or there is water, a burning smell or a tripped breaker, stop using the appliance and book a visit with the full model number.

05

About F03

Viking describes code F03 on this range with the wording “cooling fan feedback fault”.

MeaningCooling fan Hall-effect: control not receiving a square wave in the allowed frequency range. Cancels bake or clean. Range: Clean on, Cycle flashes 3.
Applies toRanges and wall ovens with EOC4 control; wall ovens with TOD2/TOD3 clock show the F code, ranges show it as Cycle/Clean light flashes
CodeF03
06

Service procedures

The technical reference identifies the following procedures.

  • Turn cycle off, power down and correct the cooling fan issue.
07

Other messages and alarms

  • F06 — Invalid model header: model header undefined, read at power-up; control inoperable. Range: Clean on, Cycle flashes 2.
  • F04 — Meat probe input shorted. Cancels cook-by-probe operation (priority B, non-critical).
  • F02 — RTD (oven temperature sensor) open or short. Cancels cook and clean cycles; control inoperable. Range: Cycle light flashes once, Clean light off.
08

What to check without opening panels

Give details of the selected cooking settings when discussing the appliance concern. Identify the affected cooking area in the service request. Leave the concealed appliance wiring undisturbed until a technician has seen the appliance.

09

Repair appointments in Dallas

When requesting service, provide the equipment model and any fault message and describe any changes in normal use. The cause is assessed before work is proposed; the findings lead to a written repair estimate, and you approve repairs before repair work begins. Arrange diagnosis.

10

Sources

11

Questions about this code

What does F03 mean on a Viking range?

The manual describes the indication as “cooling fan feedback fault”. Match the model and control version before following the instructions.

What should I do before requesting range service?

Include information about the selected heating mode without repeating unsafe operation. Report the setting in use when trouble began. Leave all enclosed wiring connections intact for the service professional.

13

Range models on file

All models

14

Work order

Book a Viking technician

Read the model and serial number off the rating plate and add them to the request — the technician checks parts for that exact unit before the visit.

Request a Viking repair

Ready to get your Viking appliance working again?

Diagnosis first, a written estimate before any work, parts matched to the full model number.

(415) 853-4850 Book a Repair