Viking Range error code
Viking Range F09 Error Code
What F09 means on a Viking range, the checks that are safe to make and when it needs a technician.
F09
What it means
F09 is described as “runaway oven temperature”.
F09: runaway oven temperature.
Safe for owners
Check first
Switch the appliance off at the breaker for one minute, restore power and note whether the code returns. Nothing else should be opened or removed.
Likely cause
On most Viking appliances, F09 points to a control, sensor, ignition, heating, door-lock, water or drain issue that should be confirmed against the full model number before parts are replaced.
When to book
If the code comes back after the power reset, or there is water, a burning smell or a tripped breaker, stop using the appliance and book a visit with the full model number.
About F09
Viking describes code F09 on this range with the wording “runaway oven temperature”.
| Code | F09 |
|---|---|
| Applies to | Ranges and wall ovens with EOC4 control; wall ovens with TOD2/TOD3 clock show the F code, ranges show it as Cycle/Clean light flashes |
| Meaning | Runaway oven temperature: temperature above 650F for over 10 minutes with door unlocked. Range: Clean on, Cycle flashes 9. |
Internal fault investigation
The fault reference provides these diagnostic checks.
- Power down and test RTD for open, shorted or grounded wiring; replace EOC4 if the RTD tests OK.
Other codes in the appliance documentation
- F08 — Communication error: RS485 serial link lost between EOC4 and user interface. Range: Clean on, Cycle flashes 8.
- F10 — Improper self-clean selection: a delayed self-clean cycle was attempted. Range: Clean on, Cycle flashes 10.
- F07 — Door switch: door open during CLEAN (latch or door sensor failed, or door opened right after selecting CLEAN). Range: Clean on, Cycle flashes 7.
Notes to prepare at home
Write down the exact cooking-control message in the repair request. Include any change in the usual heating sequence. Keep the internal electrical connections untouched during owner observations.
Dallas booking details
To prepare, record the full model number and control message and describe any changes during operation. The technician investigates the operating concern first; the repair proposal includes a written repair estimate, and you approve repairs before the work starts. Request appliance service.
Sources
Questions about this code
What does F09 mean on a Viking range?
The manual describes the indication as “runaway oven temperature”. Match the model and control version before following the instructions.
What should I do before requesting range service?
Explain which oven or zone changes when arranging a visit. Tell the service professional about the setting in use when trouble began. Leave the internal electrical components undisturbed until a service technician has seen the equipment.
Range models on file
- RVER330130-inch freestanding radiant electric range with convection oven30-inch Self-Cleaning Electric Range.
- RVIR33030-inch freestanding induction range with self-cleaning electric oven30-inch Induction Range.
- TVDR36136-inch dual-fuel range with four gas burners and electric oven36-inch Tuscany Dual Fuel Range.
- TVDR48148-inch dual-fuel double-oven range48-inch Tuscany Dual Fuel Range.
Work order
Book a Viking technician
Read the model and serial number off the rating plate and add them to the request — the technician checks parts for that exact unit before the visit.
- Phone(415) 853-4850
- Emailservice
@vikingdallas .com - HoursMon–Sat 8:00 AM – 7:00 PM
- Service area11 counties across Dallas–Fort Worth
Request a Viking repair
Ready to get your Viking appliance working again?
Diagnosis first, a written estimate before any work, parts matched to the full model number.