Skip to content

Viking Refrigerator error code

Viking Refrigerator CL Error Code

What CL means on a Viking refrigerator, the checks that are safe to make and when it needs a technician.

Display readoutDallas

CLRefrigerator display code

01

CL

What it means

CL is described as “condenser cleaning reminder”.

CL: condenser cleaning reminder.

02

Safe for owners

Check first

Switch the appliance off at the breaker for one minute, restore power and note whether the code returns. Nothing else should be opened or removed.

03

Likely cause

On most Viking appliances, CL points to a control, sensor, ignition, heating, door-lock, water or drain issue that should be confirmed against the full model number before parts are replaced.

04

When to book

If the code comes back after the power reset, or there is water, a burning smell or a tripped breaker, stop using the appliance and book a visit with the full model number.

05

About CL

On a Viking refrigerator, the CL indication has this documented meaning: “condenser cleaning reminder”.

Service referenceManual recommends cleaning the condenser once every 6 months.
Applies to7 Series built-in bottom-freezer (FBI7360/VBI7360)
CodeCL
MeaningRefrigerator display blinks CL: time to clean the condenser coil. Cleared by holding UP and DOWN arrows 3 seconds after cleaning.
06

Warnings from the manual

The manual lists these operating cautions.

  • Turn off the main power switch at the top of the unit behind the top access panel before cleaning.
07

Internal fault investigation

The fault reference gives these internal checks.

  • Vacuum the front of the condenser coil with a household vacuum extension rather than a duster, which may damage the fin.
08

Possible causes in the documentation

The documentation details the following causes.

  • Condenser can clog from dust, pet hair; clean it right after construction work or dusty activity near the unit.
09

Owner troubleshooting

The operating manual gives the listed checks.

  1. Clean the condenser coil as described in the manual, then hold UP and DOWN arrows for 3 seconds.
10

Check a different display code

  • HIGH TEMPERATURE ALARM — Alarm sounds and display flashes when temperature exceeds the allowed high temperature.
  • BLUEZONE — Bluezone indicator strip shows on display: Bluezone bulb needs replacement (about every two years).
  • OPEN DOOR ALARM — Alarm sounds when a door or drawer stays open longer than 3 minutes.
11

Notes to prepare at home

Record where interior moisture appears in the repair request. Make a note of whether condensation appears near the door. Keep the concealed appliance wiring untouched during owner observations.

12

Dallas booking details

When requesting service, provide the unit model and any fault message and describe any changes in normal use. The visit starts by assessing the problem; the repair proposal includes a written repair estimate, and you approve repairs before repair work begins. Arrange diagnosis.

13

Sources

14

Questions about this code

What does CL mean on a Viking refrigerator?

The manual describes the indication as “condenser cleaning reminder”. Match the model and control version before following the instructions.

What should I do before requesting refrigerator service?

Record whether the equipment door closes when discussing the equipment concern. Tell the service technician about whether the alarm stops when the door closes. Leave the hidden electrical connections undisturbed while recording the concern.

16

Refrigerator models on file

All models

17

Work order

Book a Viking technician

Read the model and serial number off the rating plate and add them to the request — the technician checks parts for that exact unit before the visit.

Request a Viking repair

Ready to get your Viking appliance working again?

Diagnosis first, a written estimate before any work, parts matched to the full model number.

(415) 853-4850 Book a Repair