Skip to content

Viking Refrigerator error code

Viking Refrigerator HIGH TEMPERATURE ALARM Error Code

What HIGH TEMPERATURE ALARM means on a Viking refrigerator, the checks that are safe to make and when it needs a technician.

Display readoutDallas

HIGH TEMPERATURE ALARMRefrigerator display code

01

HIGH TEMPERATURE ALARM

What it means

HIGH TEMPERATURE ALARM is described as “high-temperature alarm”.

HIGH TEMPERATURE ALARM: high-temperature alarm.

02

Safe for owners

Check first

Switch the appliance off at the breaker for one minute, restore power and note whether the code returns. Nothing else should be opened or removed.

03

Likely cause

On most Viking appliances, HIGH TEMPERATURE ALARM points to a control, sensor, ignition, heating, door-lock, water or drain issue that should be confirmed against the full model number before parts are replaced.

04

When to book

If the code comes back after the power reset, or there is water, a burning smell or a tripped breaker, stop using the appliance and book a visit with the full model number.

05

About HIGH TEMPERATURE ALARM

Viking describes code HIGH TEMPERATURE ALARM on this refrigerator with the wording “high-temperature alarm”.

Applies to7 Series built-in bottom-freezer (FBI7360/VBI7360); similar alarm in VCBB5363E
MeaningAlarm sounds and display flashes when temperature exceeds the allowed high temperature.
CodeHIGH TEMPERATURE ALARM
06

Checks before the visit

The operating manual sets out the checks below.

  1. Press the alarm button to mute; display flashes until normal temperature is reached.
07

Internal checks from the manual

The fault reference gives the listed service work.

  • In the VCBB5363E manual the high temperature alarm sounds and the HIGH TEMP light glows if the refrigerator or freezer temperature is too high for two hours; a blinking light shows which part is affected.
08

Recognizing the displayed condition

The control reference sets out these display details.

  • Pressing the alarm button mutes the sound but the display keeps flashing until normal maximum temperature is reached.
09

Check a different display code

  • LONG TERM POWER LOSS — After a long power loss the display shows a power-loss indication.
  • CL — Refrigerator display blinks CL: time to clean the condenser coil. Cleared by holding UP and DOWN arrows 3 seconds after cleaning.
  • OPEN DOOR ALARM — Alarm sounds when a door or drawer stays open longer than 3 minutes.
10

Getting ready for diagnosis

Provide details about when cooling behavior changes when arranging a visit. Report whether the concern is constant or intermittent. Leave the appliance service panels alone before the diagnostic visit.

11

When to request service in Dallas

Have ready the equipment identification details and explain which owner checks were attempted. The technician investigates the reported problem first; a written estimate follows, and you approve repairs before repair work begins. Arrange diagnosis.

12

Sources

13

Questions about this code

What does HIGH TEMPERATURE ALARM mean on a Viking refrigerator?

The manual describes the indication as “high-temperature alarm”. Match the model and control version before following the instructions.

What should I do before requesting refrigerator service?

Note a door-related alarm when discussing the appliance concern. Tell the appliance technician about whether the alarm stops when the door closes. Keep the concealed appliance wiring intact for the service professional.

15

Refrigerator models on file

All models

16

Work order

Book a Viking technician

Read the model and serial number off the rating plate and add them to the request — the technician checks parts for that exact unit before the visit.

Request a Viking repair

Ready to get your Viking appliance working again?

Diagnosis first, a written estimate before any work, parts matched to the full model number.

(415) 853-4850 Book a Repair