Viking Induction cooktop error code
Viking Induction Cooktop 4 FLASHES Error Code
What 4 FLASHES means on a Viking induction cooktop, the checks that are safe to make and when it needs a technician.
Display readoutDallas
4 FLASHESInduction cooktop display code
4 FLASHES
What it means
4 FLASHES is described as “coil temperature sensor malfunction”.
4 FLASHES: coil temperature sensor malfunction.
Safe for owners
Check first
Switch the appliance off at the breaker for one minute, restore power and note whether the code returns. Nothing else should be opened or removed.
Likely cause
On most Viking appliances, 4 FLASHES points to a control, sensor, ignition, heating, door-lock, water or drain issue that should be confirmed against the full model number before parts are replaced.
When to book
If the code comes back after the power reset, or there is water, a burning smell or a tripped breaker, stop using the appliance and book a visit with the full model number.
About 4 FLASHES
For a Viking induction cooktop, code 4 FLASHES carries the documented description “coil temperature sensor malfunction”.
| Meaning | Induction LED flash code: 4 consecutive flashes = coil temperature sensor malfunction. |
|---|---|
| Code | 4 FLASHES |
| Control generation | Legacy |
| Applies to | Built-in electric radiant/induction cooktop (F20111C) and built-in induction rangetop (F20114) Use & Care Internal Error Codes table; LED indicators with brief interval between flash groups |
Other messages and alarms
- 6 FLASHES — Induction LED flash code: 6 consecutive flashes = incompatible cookware for induction.
- 2 FLASHES — Induction LED flash code: 2 consecutive flashes = internal power device malfunction.
- Er47 — LEDs flash 5 times then pause and 7-digit display shows Er47: wrong configuration program (C1-C6) in the interface adapter board.
Preparing for an appliance assessment
Record how heating differs from normal before deciding on repair work. Keep the chosen cooking function with the symptom description. Leave the electrical service covers undisturbed while recording the concern.
Dallas service and preparation
Have ready the appliance model information from the appliance identification label and mention whether the operating concern returns. Assessment precedes decisions about the repair; the repair proposal includes a written estimate, and the repair proceeds only after your agreement. Book an assessment.
Sources
Questions about this code
What does 4 FLASHES mean on a Viking induction cooktop?
The manual describes the indication as “coil temperature sensor malfunction”. Match the model and control version before following the instructions.
What should I do before requesting induction cooktop service?
Make a note of where the heating concern occurs alongside the chosen operating settings. Write down which operating mode was selected. Leave the unit service panels undisturbed until a repair technician has seen the equipment.
Induction cooktop models on file
Work order
Book a Viking technician
Read the model and serial number off the rating plate and add them to the request — the technician checks parts for that exact unit before the visit.
- Phone(415) 853-4850
- Emailservice
@vikingdallas .com - HoursMon–Sat 8:00 AM – 7:00 PM
- Service area11 counties across Dallas–Fort Worth
Request a Viking repair
Ready to get your Viking appliance working again?
Diagnosis first, a written estimate before any work, parts matched to the full model number.