Viking Induction cooktop error code
Viking Induction Cooktop 2 FLASHES Error Code
What 2 FLASHES means on a Viking induction cooktop, the checks that are safe to make and when it needs a technician.
Display readoutDallas
2 FLASHESInduction cooktop display code
2 FLASHES
What it means
2 FLASHES is described as “internal power device malfunction”.
2 FLASHES: internal power device malfunction.
Safe for owners
Check first
Switch the appliance off at the breaker for one minute, restore power and note whether the code returns. Nothing else should be opened or removed.
Likely cause
On most Viking appliances, 2 FLASHES points to a control, sensor, ignition, heating, door-lock, water or drain issue that should be confirmed against the full model number before parts are replaced.
When to book
If the code comes back after the power reset, or there is water, a burning smell or a tripped breaker, stop using the appliance and book a visit with the full model number.
About 2 FLASHES
On a Viking induction cooktop, the 2 FLASHES indication has this documented meaning: “internal power device malfunction”.
| Meaning | Induction LED flash code: 2 consecutive flashes = internal power device malfunction. |
|---|---|
| Code | 2 FLASHES |
| Applies to | Built-in electric radiant/induction cooktop (F20111C) and built-in induction rangetop (F20114) Use & Care Internal Error Codes table; LED indicators with brief interval between flash groups |
| Control generation | Legacy |
Additional fault references
- 5 FLASHES — Induction LED flash code: 5 consecutive flashes = inside ambient temperature too high.
- 3 FLASHES — Induction LED flash code: 3 consecutive flashes = power device temperature sensor malfunction.
- 1 FLASH — Induction LED flash code: 1 flash with brief interval = internal power device over temperature.
Before requesting a visit
Make a note of changes after routine owner care as part of the symptom description. Keep moisture away from exposed electrical connections. Leave the enclosed control circuits untouched during owner observations.
Booking a Dallas repair visit
For the initial discussion, have the full model number and displayed message, plus the original display wording. The visit begins with diagnosis; a written estimate follows, and work waits for your agreement. Send a service request.
Sources
Questions about this code
What does 2 FLASHES mean on a Viking induction cooktop?
The manual describes the indication as “internal power device malfunction”. Match the model and control version before following the instructions.
What should I do before requesting induction cooktop service?
Include information about where the heating concern occurs without assuming a failed component. Tell the appliance technician about the setting in use when trouble began. Leave the concealed appliance wiring untouched during owner-accessible care.
Induction cooktop models on file
Work order
Book a Viking technician
Read the model and serial number off the rating plate and add them to the request — the technician checks parts for that exact unit before the visit.
- Phone(415) 853-4850
- Emailservice
@vikingdallas .com - HoursMon–Sat 8:00 AM – 7:00 PM
- Service area11 counties across Dallas–Fort Worth
Request a Viking repair
Ready to get your Viking appliance working again?
Diagnosis first, a written estimate before any work, parts matched to the full model number.